Set Command Device Security (CommandDevSec) Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[Install],Set CommandDevSec,,Normal end,,,Seq.=xxxxx
+{LDKC:CU:LDEV,CommandDevSec}=[{0x00:0xXX:0xXX,Disable},{0x00:0xXX:0xXX,Enable}],
Num. of LDEVs=2
[Install]
Install function
Set CommandDevSec
Set CommandDevSec operation
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
Detailed information displays for this operation, as shown in Table 145.
Table 145 Set CommandDevSec Operation
DescriptionItem
The LDKC, CU, and LDEV numbers of the logical volume where the command device is
set
LDKC:CU:LDEV
Indicates whether the command device security setting is enabled or disabled
Disable or Enable will appear.
CommandDev
The number of logical volumes where the command device is setNum. of LDEVs
Set Encryption Key Operation
See “Install Function — Set Encryption Key Operation” on page 341.
Set Fibre Address Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[Install],Set Fibre Address,,Normal end,,,Seq.=xxxxx
+{Port,Fibre Addr.}=[{XX,1},{XX,126}],Num. of Ports=2
[Install]
Install function
Set Fibre Address
Set Fibre Address operation
Normal end
The operation has ended normally.
Install Function180
To Next Page
Loading...
