HP StorageWorks XP20000/XP24000 - Disk Array - Page 241

DescriptionItem
The rate type of the All Thresholds value.
IOPS: I/O rate, KB/s: Transfer rate
This value is output only when the All Thresholds value is set.
Mode
Set Ctrl Kind Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[Perf Ctrl],Set Ctrl Kind,Kind=WWN,Normal end,,,
Seq.=xxxxx
[Perf Ctrl]
XP Performance Control (Perf Ctrl) function
Set Ctrl Kind
Set Ctrl Kind operation
Kind=WWN
WWN is selected as the parameter. The operation uses the following parameters, as shown in Table
218.
Table 218 Parameters for Set Ctrl Kind Operation
DescriptionParameter
Port Control is applied without the All Thresholds value being set.Port
Port Control is applied with the All Thresholds value being set.All Port
WWN Control is applied. This value is output whether the All Thresholds value is set or
not.
WWN
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295).
Set Priority (Prio) Port Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[Perf Ctrl],Set Prio Port,,Normal end,,,
Seq.=xxxxx +{Port,Priority,Use,Threshold/Upper Limit,Mode}=[{1A,Non-Prio,
Enable,XXXXXXXX,IOPS},{3A,Prio,Disable,,}],Num. of Ports=2
[Perf Ctrl]
XP Performance Control (Perf Ctrl) function
Set Prio Port
Set Prio Port operation
Normal end
XP24000/XP20000 Audit Log User and Reference Guide 241