The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
Detailed information displays for this operation, as shown in Table 219.
Table 219 Set Prio Port Operation
DescriptionItem
The port name.Port
The attribute set to the port.
Prio: Prioritized port, Non-Prio: Non-prioritized port
Priority
The channel type of path interface. Indicates whether the threshold is set or not in case
of the prioritized port and whether the upper limit value is set or not in case of
non-prioritized port.
Enable: Value is set, Disable: Value is not set.
Use
The threshold in case of prioritized port and the upper limit value in case of non-prioritized
port. This value is output only when the threshold or the upper limit value is set.
Threshold/ Upper
Limit
The type of rate used for upper limit control and threshold control.
IOPS: I/O rate, KB/s: Transfer rate.
This value is output when the threshold or the upper limit value is set.
Mode
The number of ports that the setting is changed.Num. of Ports
Set Priority (Prio) WWN Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[Perf Ctrl],Set Prio WWN,,Normal end,,,
Seq.=xxxxx +{WWN,Priority,Upper Limit,Mode}=[{0xXXXXXXXXXXXXXXXX,
Non-Prio,XXXXXXXX,IOPS}],Num. of WWNs=1
[Perf Ctrl]
XP Performance Control (Perf Ctrl) function
Set Prio WWN
Set Prio WWN operation
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
XP Performance Control (Perf Ctrl) Function242
To Next Page
Loading...
