Detailed Information
Detailed information displays for this operation, as shown in Table 292.
Table 292 Set Fixed PG Operation
DescriptionItem
The executed operation to the parity group.
Set: Set to the fixed parity group, Release: Set to the normal parity group.
Type
ID of the parity group whose settings are changed.PG
The number of parity groups whose settings are changed.Num. of PGs
Set Migration Vol Operation
This logged information indicates that the migration was only requested, but not finished. For
information on using XP Auto LUN, see the HP StorageWorks XP24000/XP20000 Auto LUN Software
User's Guide.
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[Auto LUN],Set Migration Vol,,Normal end,,,Seq.=xxxxxx
+{Instruction,SourceLDEV,TargetLDEV,OwnerID,Result}=[{Create,0x00:0x00:0x00,0x00:
0x00:0x01,
0xFF,Normal end},{ Create,0x00:0x00:0x02,0x00:0x00:0x03,0xFF, Error(XXXX-YYYY) end },
{ Create,0x00:0x00:0x04,0x00:0x00:0x05,0xFF,Normal end},
{ Create,0x00:0x00:0x06,0x00:0x00:0x07,0xFF, Error(XXXX-YYYY) end }] Num. of LDEVs =4
[Auto LUN]
HP XP Auto LUN Software function
Set Migration Vol
Set Migration Vol operation
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
Detailed information displays for this operation, as shown in Table 293.
Table 293 Set Migration Vol Operation
DescriptionItem
Indicates that the manual migration plan is set or deleted; Create: Set, Delete: DeletedInstruction
The logical volume ID of the migration source. The number on the left of the colon is an
LDKC number, the number between the colons is a CU number and the number on the
right of the colon is an LDEV number.
SourceLDEV
XP24000/XP20000 Audit Log User and Reference Guide 317
To Next Page
