DescriptionItem
The logical volume ID of the migration target. The number on the left of the colon is an
LDKC number, the number between the colons is a CU number and the number on the
right of the colon is an LDEV number. This value is output only when the manual migration
plan is set.
TargetLDEV
The program which set this migration plan; for HP XP Auto LUN Software, 0x00 is output.
For a program other than HP XP Auto LUN Software, the ID of the program product is
output.
OwnerID
The result of operation.
Normal end: Normal end, Error(xxxx-yyyyy): Abnormal end, Not Execute: Not executed
xxxx: Part code, yyyyy: Error code
Result
The number of manual migration plans set and deleted.Num. of LDEVs
Set Plan Condition Operation
user-name,xx,YYYY/MM/DD,HH:MM:SS.xxx, 00:00,[Auto LUN], Set Plan Condition,,Normal end,,,
Seq.=xxxxx
+{SetType,StartTime,TimeRequiredMax(min.),AvailablityMax(%),VolumeMax} =
[{Default,24:00,120,100,65535}] Num. of Data = 1
[Auto LUN]
HP XP Auto LUN Software function
Set Plan Condition
Set Plan Condition operation
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (0000000000 to 4294967295)
Detailed Information
Detailed information displays for this operation, as shown in Table 294.
Table 294 Set Plan Condition Operation
DescriptionItem
The executed operation.
Default: The default auto migration plan is applied (click the Default button, and then
click the Set button).
Customize: The customized auto migration plan is applied (click the Set button after
changing the value of the auto migration plan parameter).
SetType
The specified start time of the auto migration, that is, the time when the auto migration
plan execution starts.
StartTime
XP Auto LUN Software Function318
To Next Page
