for the process to complete. During this time the product will be online but several warning events will
be generated and the GUI Hardware Report will show errors being reported and cleared.
8. Use the StoreOnce GUI or StoreOnce CLI to check that the firmware on the new component is correct.
See Upgrading BIOS or hardware firmware components on page 16.
NOTE: The system reboots after a firmware upgrade, but for some components a cold reboot is
required to complete the process. A message is displayed after the reboot if a cold reboot is also
required. Power down the system, wait the time recommended in the message and then power on
again using the Power On button.
The HP p1224 RAID controller 39
To Next Page
Loading...
