Figure 16: SuperCapacitor module connector on RAID card
1 SuperCapacitor connector 2 LEDs
4. Replace the cover and power up the HPE StoreOnce Backup system. Check the status of the system
on the Hardware page of the StoreOnce GUI. If this does not resolve the problem, the associated
RAID card may need replacing.
5. Use the StoreOnce GUI or StoreOnce CLI to check that the firmware on the new component is correct.
See Upgrading BIOS or hardware firmware components on page 16.
NOTE: Note the output at command completion. It will advise if you need a system reboot or a cold
reboot to install the new firmware revision successfully.
44 RAID cache module and SuperCapacitor failures
To Next Page
Loading...
