4. Reconfigure the storage for the appliance using the commands:
hardware discover storage
hardware add storage
5. Monitor the expansion using the following command:
system show status
This command will return either of the following after an add command has been sent:
• Adding X,XXXGB...
• Formatted XXGB, which means that the storage and file system has been configured and is
ready for use. Parity initialization may still be in progress.
The following output is an example; the values shown may not match your appliance-specific values.
# system show status
Status
------
Formatted 15,070.76GB
Service Sets Status Notes
------------ ------ -----
Set 1 Running
NOTE: The addition of storage will take a minimum of two hours to complete. You will not be able to
complete the next steps until storage is formatted.
6. Using an SFTP client copy the saved configuration zip file to the config folder on the appliance.
• Using Linux
a. sftp Admin@<IP_address>
b. cd config
c. put <config_filename>.zip
d. exit sftp
• Using a Windows sftp client
a. Ensure that the File Protocol is set to SFTP, not SCP.
b. Login as Admin.
c. Copy <config_filename>.zip to config.
7. Use the following StoreOnce CLI command to check that the file has been uploaded:
config show list
8. Run the StoreOnce CLI command:
config restore devices <config_filename>
74 The QR ISO image
To Next Page
Loading...
