HP t5740e - Thin Client - Installing the Antenna (Wireless Models); Installing the Rubber Feet; Installing the Stand

Installing the Antenna (Wireless Models)
▲
Screw the antenna in place on the rear of the thin client.
Figure 1-5 Installing the antenna
CAUTION: To prevent damage to the antenna mounting, do not overtighten the antenna.
Installing the Rubber Feet
To install the rubber feet:
1. Lay the thin client on its right side.
2. Remove the feet from their backing.
3. Press each foot down securely onto a corner of the left side of the thin client.
Figure 1-6 Installing the rubber feet
Installing the Stand
If the thin client will be installed in an vertical orientation and it will not be mounted, the stand should
be installed for stability.
ENWW
Installing the Antenna (Wireless Models)
5