Installing the USB Device
Before beginning the replacement process, review General Hardware Installation Sequence
on page 11 for procedures you should follow before and after installing or replacing hardware.
▲
Insert the USB device into the USB port in the secure USB compartment. See the following
illustration for the location of the ports in the secure USB compartment.
Figure 2-7 USB ports in the secure USB compartment
Removing and Replacing the Battery
Before beginning the replacement process, review General Hardware Installation Sequence
on page 11 for procedures you should follow before and after installing or replacing hardware.
WARNING! You must remove the right side panel to access the battery. Before removing the side
access panel, ensure that the thin client is turned off and the power cord is disconnected from the
electrical outlet.
To remove and replace the battery:
1. Locate the battery on the system board.
ENWW
Installing Thin Client Options
17
To Next Page
Loading...
Need help?
General