To Next PageTo Next PageWhat to do if my HP T750 G4 INTL is overloaded?
If your HP UPS is overloaded, it means the power requirement exceeds the UPS capacity (greater than 105% of nominal). To resolve this, remove some of the equipment from the UPS. The UPS will continue to operate, but might shut down if the load increases. The alarm will reset when the condition becomes inactive.
General| Topology | Line Interactive |
|---|---|
| Surge Energy Rating | 320 Joules |
| Form Factor | Tower |
| Surge Protection | Yes |
| Model | T750 G4 INTL |
| Power Rating | 750 VA |
| Output Voltage | 230 VAC |
| Input Frequency | 50/60 Hz |
| Output Frequency | 50/60 Hz |
| Transfer Time | Typical 4 ms |
| Battery Type | Sealed Lead Acid (SLA) |
| Typical Recharge Time | 8 hours |
| Audible Alarm | Yes |
| Operating Temperature | 0 to 40°C |
| Operating Relative Humidity | 0 to 95% non-condensing |
| Communication Interface | USB |
| Warranty | 2 years |
