To Next Page

To Previous Page

Component identification 12

must be connected to a remote, normally-open switch (not supplied). The REPO switch is used in

conjunction with a main disconnect device that removes the AC source from the input of the UPS. When

the switch is closed:

• The REPO feature immediately powers down protected devices and does not utilize the orderly

shutdown procedure initiated by power management software.

• The REPO feature shuts down UPS units operating under either utility or battery power.

NOTE: If the UPS was operating on battery power when the remote switch was closed, no

power is available to the load devices until utility power is restored and the UPS has been

manually powered up.

To restore power to the load devices after the REPO feature is activated, press the On button after the AC

source is reconnected to the UPS.

IMPORTANT: Pressing and holding the On button without utility present normally initiates a

battery start and the UPS assumes the load. However, if the On button is pressed and a REPO

is detected, battery start is inhibited and the UPS is not able to assume the load. The

electronics module fan spins, and the Self Test, Battery Fault, Site Wiring Fault, and

Overtemperature LEDs and an audible alarm are active as long as the On button is held.

To power down the entire network in the event of an emergency, the REPO ports of multiple UPS units can

be connected to a single switch.

ERM rear panel

Item Description

1 Circuit breaker

2 ERM output connector cable (to the UPS)

3 ERM input connector (from another ERM)

Questions and Answers:

Need help?

Do you have a question about the HP UPS R/T3000 and is the answer not in the manual?

HP UPS R/T3000 Specifications

General