To Next Page

To Previous Page

2. Insert screws through the rack into the mounting rail and

the front of each mounting bracket.

3. Install cage nuts or clip nuts into the rear of the rack.

4. Insert screws through the mounting rail into the cage nuts

or clip nuts.

5. Tighten the hex nuts.

Preparing the rails for

integrated shipping

If the unit is to be shipped in an HP 9000 or

10000 series rack:

1. Remove the hex nuts, flat washers, and lock washers

from the mounting rail.

2. Install the rail reinforcement plates and tighten using the

hex nuts with captive washers included in the kit, instead

of the nuts included with the rail.

3. Install the rear mounting brackets using hex nuts. Wait

until the unit is installed and the brackets are adjusted

before tightening the nuts.

Questions and Answers:

Need help?

Do you have a question about the HP UPS R5500 ERM and is the answer not in the manual?

HP UPS R5500 ERM Specifications

General