114 Chapter5
Boot Console Handler
Displaying and Setting Paths
To set a system path to a new value, follow the directions in the section “Accessing the Boot
Console Handler” found in this chapter, and type the following at the prompt:
Main Menu: Enter command > path
path_type path
[Enter]
where
path_type
is one of the path types listed in Table 5-1 and
path
is the specification of
the path in Mnemonic Style Notation (as described in Table 5-2). For example, to set the
primary boot path to a SCSI disk with an ID of 6.0, follow the directions in “Accessing the
Boot Console Handler” on, and then type the following at the prompt:
Main Menu: Enter command > path pri scsi.6.0 [Enter]
To Next Page
Loading...
