HP Visualize j6000 - Setting the Auto Boot and Auto Search Flags

Chapter 5 123
Boot Console Handler
Setting the Auto Boot and Auto Search Flags
Setting the Auto Boot and Auto Search Flags
The auto boot and auto search flags are variables stored in the system’s non-volatile
memory. (Non-volatile memory retains its contents even after power is turned off.) If you
reset these flags to new values, the change takes effect the next time you reboot the
workstation.
To examine the state of the auto boot and auto search flags, type the following:
Configuration Menu: Enter command > auto [Enter]
If auto boot is set to on, the workstation automatically attempts to boot the operating
system when powered on. If auto boot is set to off, the workstation enters the boot
administration mode of the Boot Console Handler.
The state of the auto search flag determines how the workstation seeks a boot device
during autoboot. If auto search is set to on, the workstation will search for other boot
devices if the primary boot device is not available. If auto search is off, the workstation
will default to the boot administration mode if it can’t see the primary boot device.
To change the state of the auto boot or auto search flags, type either:
Configuration Menu: Enter command > auto boot state [Enter]
OR:
Configuration Menu: Enter command > auto search state [Enter]
where state is on or off.