HP W1907 - 19" LCD Monitor User Manual

Setting Up the Monitor
User’s Guide 3–7
Removing the Monitor Base
You can remove the monitor base to mount the monitor on a wall,
a swing arm or other mounting fixture. Read the caution and
warning statements below before beginning the procedure.
Ä
CAUTION: Before beginning to disassemble the monitor, be sure
the monitor is turned off and the power and signal cables are both
disconnected.
Lay the front bezel down on a soft area to prevent it from getting
scratched, defaced, or broken.
Å
WARNING: Do not remove the base from the monitor while the
monitor is in the upright position. Before removing the monitor from
the base, ensure that the monitor is lying flat, front bezel down, and
that the base is set to the maximum base extension. Attempting to
remove the monitor from the base while it is upright in the minimum
base extension may result in injury to the user.

HP W1907 - 19" LCD Monitor Specifications

General

Screen Size	19 inches
Resolution	1440 x 900
Aspect Ratio	16:10
Brightness	300 cd/m²
Contrast Ratio	1000:1
Response Time	5 ms
Viewing Angle	160° horizontal, 160° vertical
Input Video Compatibility	Analog RGB, Digital
Pixel Pitch	0.285 mm
Inputs	VGA
Power Consumption	2 W (standby)