• Close the DKC Status window.
• Click File > Refresh on the menu bar.
• Select Modify mode when you are in View mode.
Use the DKC Operation window to:
• “Configure storage systems for Continuous Access Journal Z, define logical paths ” (page 57)
• “Configure additional logical paths ” (page 59)
• View one of the following:
“Remote Systems Information ” (page 172)◦
◦ “Logical Path Information” (page 173)
◦ “Port Information for the local system” (page 173)
NOTE: DKC is an acronym for disk controller, which controls an entire storage system. Cnt Ac-J
Z windows use the term "DKC" to indicate a storage system.
LDKC is an acronym for logical disk controller, and it also may be called logical DKC. LDKC is a
controller that controls a logical storage system that exists in P9500. In the Cnt Ac-J Z window, the
term “LDKC” indicates a logical storage system.
DescriptionItem
Changes information in the DKC Operation window.Display
• DKC shows information about the remote storage systems and the logical paths.
• Port shows information about ports on the local storage system.
Shows either of the following, depending on the selection in Display.Tree
• Remote storage systems.
• Channel adapters on the local storage system and port attributes.
Shows information about one of the following, depending on what is selected in Display and
Tree:
Operation
• Remote storage systems. See “Remote Systems Information ” (page 172).
• Logical paths. See “Logical Path Information” (page 173).
• Ports on the local storage system. See “Port Information for the local system” (page 173).
DKC Operation window 171
To Next Page
Loading...
