REMOVAL AND REPLACEMENT OF COMPONENTS 101
Chapter 4
For example, if the drive must be set to 3, the drive might show that the 4 ID bits are at the far left of the
connector (ID0, ID1, ID2, and ID3), then using the jumpers provided, cover each block to set the SCSI
ID.
After you have given the hard drive a unique SCSI ID, you can install the hard drive into your system.
1 Select a drive bay in which to install the drive. If installing more than one hard drive, use the hard
drive order in the following image.
If installing the hard drive into the 5.25-inch bay, you must install the optional bracket (page 104).
2 Simultaneously disengage the green tabs of the rail assembly and slide the rails out of the empty bay.
3 Attach the rails to the hard drive by first inserting the hard drive rail assembly pins into one side of the
hard drive screw holes. Next, gently flex open the opposite side of the hard drive rail assembly and
insert the remaining pins into the holes in the hard drive. If installing the hard drive into the 5.25-inch
bay, skip this step.
3
2
1
To Next Page
Loading...
