102 REMOVAL AND REPLACEMENT PROCEDURES
4 Push the drive into the selected bay until it snaps into place. Then attach the power and SCSI cable
to the drive.
5 Insert the SCSI controller card into an available PCI expansion slot (page 91).
6 Connect the SCSI cable to the SCSI controller card.
7 Connect the hard drive LED cable to the SCSI card and to the system board. The LED header
location is available on the system board image on the access panel.
The hard drive cable might have extra connectors for other hard drives, but for clarity those
connectors have been omitted in the following image.
To Next Page
Loading...
