90 REMOVAL AND REPLACEMENT PROCEDURES
PCI or PCI Express Removal
1 Disconnect power from the system (page 68), remove the access panel (page 74), lay the
workstation on its side with the system board facing up, remove the PCI retainer (page 88), and
remove PCI card support (page 87), if necessary.
2 Lift the PCI levers by first pressing down on them and then out.
3 Lift the PCI card out of the chassis. If removing a PCI Express card, remove the power supply cable
(not illustrated), if required, and move the “hockey stick” lever to release the card and lift it out of the
chassis. Store the card in an anti-static bag.
4 Close the PCI levers.
Figure 4-1 PCI Removal
Figure 4-1 PCI Express Removal
To Next Page
Loading...
