Front bezel security
The front bezel can be secured in place by installing a screw through the front of the chassis into the front
bezel.
1. Prepare the computer for disassembly (Preparation for disassembly on page 17)
2. Remove the access panel (Access panel on page 18)
3. Remove the silver 6-32 security screw located on the chassis.
4. Make sure the front bezel is installed on the chassis.
5. Install the security screw through the hole in the center retainer tab on the front bezel to secure the
bezel in place.
6. Replace the computer access panel.
20 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
