HP Z1 Entry Tower G5

Speaker
The speaker is attached to the front of the chassis. Remove it from the inside of the chassis.
1. Prepare the computer for disassembly (Preparation for disassembly on page 17).
2. Remove the access panel (Access panel on page 18).
3. Remove the front bezel (Front bezel on page 19).
4. Disconnect the power and data cables from the rear of the drives in the drive cage.
5. Rotate the drive cage up (see Drive cage on page 27)
6. Disconnect the speaker cable from the system board connector labeled SPKR (1).
7. Remove the speaker cable from the clip on the bottom of the chassis (2).
8. Remove the Torx T15 screw (3) that secures the speaker to the chassis.
9. Remove the speaker from the chassis (4).
To replace the speaker, reverse the removal procedures.
60 Chapter 4 Removal and replacement procedures