Removing and installing an Optane memory module
IMPORTANT: An Optane memory module can be installed in either M.2 connector on the system board. If
replacing the module, be sure to install the new module in the same connector as the old module.
1. Prepare the computer for disassembly (Preparation for disassembly on page 17)
2. Remove the access panel (Access panel on page 18)
3. Remove the front bezel (Front bezel on page 19).
4. Disconnect the power and data cables from the rear of the drives in the drive cage.
5. Rotate the drive cage up (see Drive cage on page 27)
6. To remove an Optane memory module, remove the Phillips screw (1), and then pull the Optane memory
module away from the connector (2).
7. To install an Optane memory module, insert the new module into the connector (1), and then install the
screw (2).
8. Rotate the drive cage down (see Drive cage on page 27)
9. Connect the power and data cables to the rear of the drives in the drive cage.
10. Reassemble the computer.
44 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
