7. Remove the four mounting screws (two on each side) from the old drive. You will need these screws if
you install a new drive.
Installing a 3.5-inch hard drive
1. Prepare the computer for disassembly (Preparation for disassembly on page 17)
2. Remove the access panel (Access panel on page 18)
3. Remove the front bezel (Front bezel on page 19).
4. Install mounting screws on the sides of the hard drive using standard 6-32 silver-and-blue mounting
screws.
NOTE: 6-32 mounting screws can be purchased from HP.
If you are replacing a drive, transfer the mounting screws from the old drive to the new drive.
● Install four silver-and-blue 6-32 mounting screws (two on each side of the drive).
36 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
