Removing a 2.5-inch hard drive
1. Prepare the computer for disassembly (Preparation for disassembly on page 17)
2. Remove the access panel (Access panel on page 18)
3. Disconnect the power cable (1) and data cable (2) from the rear of the hard drive.
4. Pull the release lever at the rear of the drive outward (1) and lift the rear of the drive up (2). Then slide
the front of the drive back until it stops and pull the drive up and out of the drive bay (3).
40 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
