HP Z43

18
3) Lift the DP connector from the PCB.
4) Place the new component on the PCB. Be sure that it matches the PCB footprint.
5) Solder the new component.
Mini DP connector DP2
Repair the Mini DP connector:
1) Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.
2) Use a hot air gun to melt the solder on the pins.
3) Lift the Mini DP connector from the PCB.
4) Place the new component on the PCB. Be sure that it matches the PCB footprint.
5) Solder the new component.
USB-C connector USB5/USB4
Repair the USB-C connector:
1) Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.