8
Create and Install ICC Profile >
Once the printer calibration is complete, load again your new paper into the printer. When you
have defined and calibrated a new paper type, the printer automatically creates and installs the
new ICC profile; this is to be used with your paper. The process takes about 15–20 minutes and
consists of the following steps:
1. A profiling test chart is printed:
2. The test chart is allowed to dry for a period of time; the amount of time depends on
the paper type.
3. The test chart is scanned and measured using the HP Embedded Spectrophotometer.
Finished >
The new ICC profile is stored in the system folder on your computer. The profile is also stored in
the printer, so that other computers connected to the same printer can copy it.
Some applications may need to be closed and restarted in order to use a profile that has just
been created.
• Click Done and OK.
To Next Page
Loading...
