12. If it is necessary to replace the display/camera cable, lift the display/camera cable assembly (1) from the
routing path on the side of the display enclosure (2), and then remove the cable (3).
The display cable is available in the Cable Kit using spare part number 937300-001.
13. If it is necessary to replace the WLAN antenna cables, peel the transceivers from the top of the display
enclosure (1), remove the antenna cables from the routing path on the sides of the display enclosure
(2), and then remove the antenna cables (3).
NOTE: The WLAN antennas are spared with the display enclosure.
Component replacement procedures 69
To Next Page
Loading...
