Description Spare part number
500 GB 7200 RPM RAW 7mm 703267-002
500 GB 5400 RPM SATA RAW Hybrid 8 GB cache 7 mm 732000-002
1 TB 7200 RPM SATA RAW 9.5 mm 766644-002
500 GB 7200 RPM SATA FIPS RAW 7 mm 820572-002
500 GB 7200 RPM SATA RAW SED 7 mm 820573-002
HDD Hardware Kit 906117-001
Internal frame 906119-001
HDD connector bracket 907157-001
HDD board 929012-001
Before removing the hard drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Service door (see Service door on page 30).
b. Battery (see Battery on page 31).
c. Base enclosure (see Base enclosure on page 33).
Remove the hard drive:
1. Disconnect the hard drive connector (1).
2. Remove 2 Phillips screws (2) from the hard drive bracket.
3. Loosen the four captive screws (3) that secure the hard drive to the bottom cover.
34 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To Next Page
Loading...
