4. Lift the tab (4), and remove the primary hard drive (5).
5. If it is necessary to replace the hard drive connector adapter on the primary hard drive, slide the adapter
(1) o of the front end of the hard drive, and then remove the cable from the adapter (2).
Remove the internal frame:
▲
Remove 3 screws (1), and then remove the internal frame (2).
Remove the secondary hard drive (select products only):
1. Disconnect the hard drive connector (1).
2. Remove 2 Phillips screws (2) from the hard drive bracket.
Component replacement procedures 35
To Next Page
Loading...
