NOTE: The webcam module and microphone module are similar in appearance and installed in the
same location. The removal procedures are the same for both modules.
CAUTION: Handle the module with caution. This module has a thin prole and is susceptible to damage
when not handled carefully.
a. Detach the webcam or microphone module (1) from the display enclosure. (The module is attached
to the display enclosure with double-sided adhesive.)
b. Remove the tape (2) covering the cable.
c. Disconnect the module cable (3) from the module.
7. If it is necessary to replace the Dream Color calibration board:
a. Disconnect the calibration board cable (1) from the board.
Component replacement procedures 71
To Next Page
Loading...
