HP zl2 User Manual

9
Installing the Power Supply
source fails, the switch will continue to run. Using a twisty, secure the
power cord to the plug handle to prevent the power cord from accidentally
disconnecting from the Power Supply.
Note The Switch zl2 Internal Power Supply does not have a power switch. It is
powered ON when the power cord is connected to the supply and to a power
source.
Please see the “Installation Cautions” on page 6.
6. For J9830A, the power supply cord retention clips is required to be
secured in order to comply with local regulatory requirements. For more
information, see HP 5400R zl2 Switches Quick Setup Guide and Safety/
Regulatory Information.
Figure 6. Security Clips

HP zl2 Specifications

General

Manageable	Yes
Layer	Layer 3
Management	Web
Jumbo Frame Support	Yes
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% non-condensing
Model	HP 24-Port 10/100/1000Base-T zl Module (J8702A)