To Next Page

To Previous Page

NOTE: This apparatus is intended to be supported by a UL or CSA Listed wall mount bracket.

CAUTION: The HP Quick Release 2 can be installed directly to a wall to mount the monitor panel. It

is designed to support a maximum of up to 10.9 kg (24 lbs). If you are mounting to a wall, HP

recommends that you consult with a qualified engineering, architectural, or construction professional to

determine the appropriate type and quantity of mounting fasteners required for your application and to

ensure that the mounting solution is properly installed to support applied loads.

The weight for your model can be found in Technical Specifications on page 42.

Before you begin, make sure the monitor is turned off and the power and signal cables are

disconnected. Also disconnect any USB cables. To protect the panel, lay it face down on a soft, flat

surface.

Mounting the ZR2040w Panel

1. Remove the four screws holding the panel to the pedestal.

2. To mount the panel, use the four holes surrounding the HP logo on the back of the monitor.

Figure 3-12 Mounting the ZR2040w Model

CAUTION: This monitor supports the VESA industry standard 100 mm mounting holes. To

attach a third-party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm long

screws are required. Longer screws must not be used because they may damage the monitor. It is

important to verify that the manufacturer’s mounting solution is compliant with the VESA standard

and is rated to support the weight of the monitor display panel. For best performance, it is

important to use the power and video cables provided with the monitor.

3. If you mount the panel in portrait orientation, you will need to rotate the image to match. See

Portrait Orientation on page 24 for instructions.

16 Chapter 3 Setting Up the Monitor ENWW

Questions and Answers:

Need help?

Do you have a question about the HP ZR2240w and is the answer not in the manual?

HP ZR2240w Specifications

General

3D	No
Pixel pitch	0.248 x 0.248 mm
Aspect ratio	16:9
Response time	8 ms
Display diagonal	21.5 \
Display technology	LED
Contrast ratio (dynamic)	2000000:1
Contrast ratio (typical)	1000:1
Display number of colors	-
Digital vertical frequency	50 - 76 Hz
Digital horizontal frequency	24 - 94 kHz
Display brightness (typical)	250 cd/m²
Supported graphics resolutions	720 x 400, 1600 x 900, 1024 x 768 (XGA), 1280 x 1024 (SXGA), 1440 x 900 (WXGA+), 1680 x 1050 (WSXGA+), 1920 x 1080 (HD 1080), 640 x 480 (VGA), 800 x 600 (SVGA)
On/off switch	Yes
USB hub version	2.0
DVI-I ports quantity	0
USB Type-A downstream ports quantity	4
LED indicators	Power
Tilt angle range	-5 - 35 °
Panel mounting interface	No mm
AC input frequency	50 - 60 Hz
Power consumption (max)	52 W
Power consumption (standby)	0.3 W
Power consumption (typical)	35 W
Certification	CSA-NRTL, CSA, FCC. CE, TUV, GOST, NOM, IRAM mark, PSB, VCCI, KC/KCC, Korea E-Standby, ISC, BSMI, \\r C-Tick, CCC, CECP, CEL
Product color	Black
Country of origin	China
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Sustainability certificates	EPEAT Gold, ENERGY STAR

Weight and Dimensions