HPE FlexFabric 5710 Series Installing

8/18/2020 HPE FlexFabric 5710 Switch Series - Installing the Switch
1/7
HPE Support Center
HPE FlexFabric 5710 Switch Series - Installing the Switch
Installing the switch
Installing the switch in a 19-inch rack
Rack-mounting procedures at a glance
Attaching the mounting brackets, chassis rails, andgrounding cable to the chassis
Mounting bracket installation positions and grounding positions on an HPE5710-54HT switch
Attaching the mounting brackets and chassis rails to the chassis
Connecting the grounding cable to the chassis
Attaching the slide rails to the rack
Mounting the switch in the rack
Grounding the switch by using a grounding strip
Link to the list of available documents
Installing the switch
Hardware installation flow

HPE FlexFabric 5710 Series Specifications

General

Model	HPE FlexFabric 5710 Series
Power Supply	AC or DC
Operating Temperature	0°C to 45°C
Routing Protocol	OSPF, BGP, RIP
Input Voltage	100-240V AC
Operating Humidity	10% to 90% (non-condensing)
Jumbo Frame Support	Up to 9216 bytes
Management	CLI, SNMP