Need help?Do you have a question about the HPE FlexNetwork 5130 HI SERIES and is the answer not in the manual?
General| Product Series | HPE FlexNetwork 5130 HI Series |
|---|---|
| Switching Capacity | 176 Gbps |
| Input Voltage | 100-240V AC |
| MAC Address Table Size | 32K |
| Management | Web, CLI, SNMP |
| Dimensions (W x D x H) | 440 x 440 x 44 mm |
| Operating Temperature | 0°C to 45°C |
| Operating Humidity | 10% to 90% (non-condensing) |
| Routing Protocol | RIP, OSPF, BGP |
| VLANs | 4096 |
Test network reachability and latency to a destination IP address.
Trace the path that packets traverse from source to destination.
Display the most recent result of an NQA operation.
Enable NTP authentication for secure time synchronization.
Apply a PoE profile to PIs for power delivery configuration.
Display power supplying information for PIs.
Enable or disable PoE on a PI.
Configure an SNMP notification target host for NMS.
Display RMON statistics for interface traffic.
Enable or disable CWMP for device management.
Add a CLI action to a monitor policy for automation.
Display CPU usage for all processes.
Enable kernel thread deadloop detection.
Capture incoming packets on an interface.
To Next Page
