182
engineid: Specifies the SNMP engine ID of the remote SNMP entity. This argument is a
case-insensitive hexadecimal string. Its length is an even number in the range of 10 to 64. All-zero
and all-F strings are invalid.
Usage guidelines
To send informs to an NMS, you must configure the SNMP engine ID of the NMS on the SNMP
agent.
The NMS accepts the SNMPv3 informs from the SNMP agent only if the engine ID in the informs is
the same as its local engine ID.
You can configure a maximum of 20 remote SNMP engine IDs.
Examples
# Set the SNMP engine ID to 123456789A for the remote entity 10.1.1.1.
<Sysname> system-view
[Sysname] snmp-agent remote 10.1.1.1 engineid 123456789A
Related commands
display snmp-agent remote
snmp-agent sys-info contact
Use snmp-agent sys-info contact to configure the system contact.
Use undo snmp-agent sys-info contact to restore the default contact.
Syntax
snmp-agent sys-info contact sys-contact
undo snmp-agent sys-info contact
Default
The system contact is Hewlett Packard Enterprise Company 3000 Hanover St Palo Alto, CA
94304.
Views
System view
Predefined user roles
network-admin
Parameters
sys-contact: Specifies the system contact, a case-sensitive string of 1 to 255 characters.
Usage guidelines
Configure the system contact for system maintenance and management.
Examples
# Configure the system contact as Dial System Operator # 27345.
<Sysname> system-view
[Sysname] snmp-agent sys-info contact Dial System Operator # 27345
Related commands
display snmp-agent sys-info
To Next Page
Loading...
Need help?
General