HPE FlexNetwork 5130 HI SERIES User Manual

131
Predefined user roles
network-admin
Parameters
index index: Specifies a PoE profile by its index number in the range of 1 to 100.
name profile-name: Specifies a PoE profile by its name, a case-sensitive string of 1 to 15 characters.
interface-range: Specifies a range of Ethernet interfaces in the form of interface-type
interface-number [ to interface-type interface-number ], where interface-type interface-number
represents the interface type and interface number. The start interface number must be smaller than
the end interface number. If an interface in the specified range does not support PoE, it is ignored
when the PoE profile is applied.
Examples
# Apply the PoE profile named forIPphone to GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] apply poe-profile name forIPphone interface gigabitethernet 1/0/1
# Apply the PoE profile with index number 1 to PIs GigabitEthernet 1/0/2 to GigabitEthernet 1/0/6.
<Sysname> system-view
[Sysname] apply poe-profile index 1 interface gigabitethernet 1/0/2 to gigabitethernet
1/0/6
Related commands
apply poe-profile
display poe-profile interface
display poe device
Use display poe device to display general PSE information.
Syntax
display poe device [ slot slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, the command displays general PSE information about all PSEs in the IRF fabric.
Examples
# Display general PSE information.
<Sysname> display poe device
Slot 1:
PSE ID Slot No. SSlot No. PortNum MaxPower(W) State Model
4 1 0 48 810.0 Off LSP6POEB

HPE FlexNetwork 5130 HI SERIES Specifications

General

Brand	HPE
Model	FlexNetwork 5130 HI SERIES
Category	Switch
Language	English