123
SNTP commands
display sntp ipv6 sessions
Use display sntp ipv6 sessions to display information about all IPv6 SNTP associations.
Syntax
display sntp ipv6 sessions
Views
Any view
Predefined user roles
network-admin
network-operator
Examples
# Display information about all IPv6 SNTP associations.
<Sysname> display sntp ipv6 sessions
SNTP server: 2001::1
Stratum: 16
Version: 4
Last receive time: No packet was received.
SNTP server: 2001::100
Stratum: 3
Version: 4
Last receive time: Fri, Oct 21 2011 11:28:28.058 (Synced)
Table 21 Command output
Field Description
SNTP server
SNTP server (NTP server). If this field displays
::
, the IPv6 address of the NTP
server has not been resolved successfully.
Stratum
Stratum level of the NTP server, which determines the clock accuracy. It is in the
range of 1 to 16. A lower stratum level represents a higher clock accuracy. A clock
with stratum level 16 is not synchronized.
Version SNTP version.
Last receive time
Time when the last message was received:
• Synced—The local clock is synchronized to the NTP server.
• No packet was received—The device has not received any SNTP session
information from the server.
display sntp sessions
Use display sntp sessions to display information about all IPv4 SNTP associations.
Syntax
display sntp sessions
To Next Page
Loading...
Need help?
General