HPE FlexNetwork 5130 HI SERIES

82
ICMP jitter/UDP jitter/voice operation view
Any NQA template view
Predefined user roles
network-admin
Parameters
value: Specifies the maximum number of hops that the probe packets can traverse, in the range of 1
to 255.
Usage guidelines
The route-option bypass-route command sets the TTL to 1 for probe packets. If you configure both
the route-option bypass-route and ttl commands for an operation, the ttl command does not take
effect.
For a successful UDP tracert operation, make sure the maximum number of hops is not smaller than
the value set in the init-ttl command.
Examples
# Set the maximum number of hops to 16 for probe packets in the ICMP echo operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] ttl 16
# In ICMP template view, set the maximum number of hops to 16 for probe packets.
<Sysname> system-view
[Sysname] nqa template icmp icmptplt
[Sysname-nqatplt-icmp-icmptplt] ttl 16
type
Use type to specify an NQA operation type and enter its view.
Syntax
type { dhcp | dlsw | dns | ftp | http | icmp-echo | icmp-jitter | path-jitter | snmp | tcp | udp-echo |
udp-jitter | udp-tracert | voice }
Default
No operation type is specified.
Views
NQA operation view
Predefined user roles
network-admin
Parameters
dhcp: Specifies the DHCP operation type.
dlsw: Specifies the DLSw operation type.
dns: Specifies the DNS operation type.
ftp: Specifies the FTP operation type.
http: Specifies the HTTP operation type.
icmp-echo: Specifies the ICMP echo operation type.