HPE FlexNetwork 5130 HI SERIES User Manual

1
Ping, tracert, and system debugging
commands
debugging
Use debugging to enable debugging for a module.
Use undo debugging to disable debugging for a module or for all modules.
Syntax
debugging module-name [ option ]
undo debugging { all | module-name [ option ] }
Default
Debugging is disabled for all modules.
Views
User view
Predefined user roles
network-admin
Parameters
module-name: Specifies a module by its name, such as arp or device. For a list of supported
modules, use the debugging ? command.
option: Specifies the debugging option for a module. Available options vary by module. To display the
debugging options supported by a module, use the debugging module-name ? command.
all: Specifies all modules.
Usage guidelines
Output from debugging commands is memory intensive. To guarantee system performance, enable
debugging only for modules that are in an exceptional condition.
The system sends generated debug messages to the device information center, which then sends
the messages to appropriate destinations based on the log output configuration. For more
information about the information center, see Network Management and Monitoring Configuration
Guide.
Examples
# Enable debugging for the device management module.
<Sysname> debugging dev
Related commands
display debugging
display debugging
Use display debugging to display the enabled debugging features for a module or for all modules.
Syntax
display debugging [ module-name ]

HPE FlexNetwork 5130 HI SERIES Specifications

General

Brand	HPE
Model	FlexNetwork 5130 HI SERIES
Category	Switch
Language	English