HPE FlexNetwork 5130 HI SERIES User Manual

181
Syntax
snmp-agent port port-num
undo snmp-agent port
Default
The device uses UDP port 161 for receiving SNMP packets.
Views
System view
Predefined user roles
network-admin
Parameters
port-num: Specifies the UDP port for receiving SNMP packets, in the range of 1 to 65535. The default
port number is 161.
Usage guidelines
After changing the port number for receiving SNMP packets, reconnect the device by using the port
number for SNMP get and set operations.
To display UDP port information, use the display current-configuration command.
Examples
# Specify the UDP port for receiving SNMP packets as 5555.
<Sysname> system-view
[Sysname] snmp-agent port 5555
# Restore the default UDP port.
<Sysname> system-view
[Sysname] undo snmp-agent port
snmp-agent remote
Use snmp-agent remote to set an SNMP engine ID for a remote SNMP entity.
Use undo snmp-agent remote to delete the SNMP engine ID of a remote SNMP entity.
Syntax
snmp-agent remote { ipv4-address | ipv6 ipv6-address } engineid engineid
undo snmp-agent remote ip-address
Default
No SNMP engine IDs are configured for remote SNMP entities.
Views
System view
Predefined user roles
network-admin
Parameters
ipv4-address: Specifies a remote SNMP entity by its IPv4 address.
ipv6 ipv6-address: Specifies a remote SNMP entity by its IPv6 address.

HPE FlexNetwork 5130 HI SERIES Specifications

General

Brand	HPE
Model	FlexNetwork 5130 HI SERIES
Category	Switch
Language	English