75
If you execute this command and the source ip command for a UDP tracert operation multiple times,
the most recent configuration takes effect.
Examples
# Specify the IP address of the interface VLAN-interface 1 as the source IP address of ICMP echo
request packets.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] source interface vlan-interface 1
# In ICMP template view, specify the IP address of the interface VLAN-interface 1 as the source IP
address of ICMP echo request packets.
<Sysname> system-view
[Sysname] nqa template icmp icmptplt
[Sysname-nqatplt-icmp-icmptplt] source interface vlan-interface 1
Related commands
source ip
source ipv6
source ip
Use source ip to configure the source IPv4 address for probe packets.
Use undo source ip to restore the default.
Syntax
source ip ip-address
undo source ip
Default
The probe packets takes the primary IP address of their output interface as the source IP address.
Views
ICMP echo/TCP/UDP echo operation view
DHCP/DLSw/FTP/HTTP/SNMP operation view
UDP tracert operation view
ICMP jitter/path jitter/UDP jitter/voice operation view
Any NQA template view
Predefined user roles
network-admin
Parameters
ip-address: Specifies the source IPv4 address for probe packets.
Usage guidelines
The specified source IPv4 address must be the IPv4 address of a local interface, and the local
interface must be up. Otherwise, no probe packets can be sent out.
For an NQA template, if the source and destination addresses have different IP versions, the source
address does not take effect.
To Next Page
Loading...
Need help?
General