216
Views
System view
Predefined user roles
network-admin
Parameters
acl-number: Specifies an ACL by its number in the range of 2000 to 2999.
name acl-name: Specifies an ACL by its name. The acl-name argument is a case-insensitive string
of 1 to 63 characters. It must start with an English letter. To avoid confusion, it cannot be all. The
specified ACL must be an existing IPv4 basic ACL.
Usage guidelines
This command is not available in FIPS mode.
Only NETCONF clients permitted by the ACL can access the device through SOAP over HTTP.
If you execute this command multiple times, the most recent configuration takes effect.
Examples
# Use ACL 2001 to allow only NETCONF clients from subnet 10.10.0.0/16 to access the device
through SOAP over HTTP.
<Sysname> system-view
[Sysname] acl basic 2001
[Sysname-acl-ipv4-basic-2001] rule permit source 10.10.0.0 0.0.255.255
[Sysname-acl-ipv4-basic-2001] quit
[Sysname] netconf soap http acl 2001
netconf soap http dscp
Use netconf soap http dscp to set the DSCP value for outgoing NETCONF over SOAP over HTTP
packets.
Use undo netconf soap http dscp to restore the default.
Syntax
netconf soap http dscp dscp-value
undo netconf soap http dscp
Default
The DSCP value is 0 for outgoing NETCONF over SOAP over HTTP packets.
Views
System view
Predefined user roles
network-admin
Parameters
dscp-value: Specifies a DSCP value in the range of 0 to 63. A larger DSCP value represents a higher
priority.
Usage guidelines
The DSCP value of an IP packet specifies the priority level of the packet and affects the transmission
priority of the packet.
To Next Page
Loading...
Need help?
General