HPE FlexNetwork 5130 HI SERIES

132
Table 23 Command output
Field Description
Slot IRF member device ID.
PSE ID ID of the PSE.
Slot No. Slot number of the PSE.
SSlot No. Sub-slot number of the PSE.
PortNum Number of PIs on the PSE.
MaxPower(W) Maximum power of the PSE.
State
PSE status:
• On—The PSE is supplying power.
• Off—The PSE is not supplying power.
• Faulty—The PSE has failed.
Model PSE model.
display poe interface
Use display poe interface to display power supplying information for PIs.
Syntax
display poe interface [ interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-type interface-number: Specifies an interface by its type and number. If you do not specify
an interface, this command displays power supplying information for all PIs.
Examples
# Display power supplying information for GigabitEthernet 1/0/1.
<Sysname> display poe interface gigabitethernet 1/0/1
PoE Status : Enabled
Power Priority : Low
Oper : Off
IEEE Class : 0
Detection Status : Disabled
Power Mode : Signal
Current Power : 0 mW
Average Power : 0 mW
Peak Power : 0 mW
Max Power : 30000 mW
Electric Current : 0 mA
Voltage : 0.0 V