HPE FlexNetwork 5130 HI SERIES User Manual

38
Expected data check takes place in the following conditions:
• For features that use the HTTP or HTTPS template, the NQA client checks for the expected
data if the response contains the Content-Length header.
• For features that use the TCP or UDP template, the NQA client checks for the expected data if
the data-fill command is configured.
The first five bytes of the UDP packet payload identify the probe packet type. The start byte of the
offset is the sixth byte of the UDP payload.
Examples
# In HTTP template view, set the expected data to welcome!.
<Sysname> system-view
[Sysname] nqa template http httptplt
[Sysname-nqatplt-http-httptplt] expect data welcome!
expect ip
Use expect ip to specify the expected IPv4 address.
Use undo expect ip to restore the default.
Syntax
expect ip ip-address
undo expect ip
Default
No expected IPv4 address is specified.
Views
DNS template view
Predefined user roles
network-admin
Parameters
ip-address: Specifies the expected IPv4 address for a DNS echo request.
Usage guidelines
During a DNS operation, the NQA client compares the expected IPv4 address with the IPv4 address
resolved by the DNS server. If they are the same, it considers the DNS server legal.
Examples
# In DNS template view, specify 1.1.1.1 as the expected IPv4 address.
<Sysname> system-view
[Sysname] nqa template dns dnstplt
[Sysname-nqatplt-dns-dnstplt] expect ip 1.1.1.1
expect ipv6
Use expect ipv6 to specify the expected IPv6 address.
Use undo expect ipv6 to restore the default.
Syntax
expect ipv6 ipv6-address

HPE FlexNetwork 5130 HI SERIES Specifications

General

Brand	HPE
Model	FlexNetwork 5130 HI SERIES
Category	Switch
Language	English