HPE FlexNetwork 5130 HI SERIES User Manual

128
Use undo sntp reliable authentication-keyid to remove the trusted key.
Syntax
sntp reliable authentication-keyid keyid
undo sntp reliable authentication-keyid keyid
Default
No trusted key is specified.
Views
System view
Predefined user roles
network-admin
Parameters
keyid: Specifies an authentication key by its ID in the range of 1 to 4294967295.
Usage guidelines
If SNTP is enabled, the SNTP client is synchronized only to an NTP server that provides a trusted
key.
Before you use the command, make sure SNTP authentication is enabled and an authentication key
is configured. The key automatically changes to untrusted after you delete the key. In this case, you
do not need to execute the undo sntp-service reliable authentication-keyid command.
Examples
# Enable NTP authentication, and specify the MD5 encryption algorithm, with the key ID of 37 and
key value of BetterKey.
<Sysname> system-view
[Sysname] sntp authentication enable
[Sysname] sntp authentication-keyid 37 authentication-mode md5 simple BetterKey
# Specify this key as a trusted key.
[Sysname] sntp reliable authentication-keyid 37
Related commands
sntp authentication-keyid
sntp authentication enable
sntp unicast-server
Use sntp unicast-server to specify an NTP server for the device.
Use undo sntp unicast-server to remove an NTP server specified for the device.
Syntax
sntp unicast-server { server-name | ip-address } [ authentication-keyid keyid | source
interface-type interface-number | version number ] *
undo sntp unicast-server { server-name | ip-address }
Default
No NTP server is specified.
Views
System view

HPE FlexNetwork 5130 HI SERIES Specifications

General

Brand	HPE
Model	FlexNetwork 5130 HI SERIES
Category	Switch
Language	English