HPE FlexNetwork 5130 HI SERIES User Manual

10
NQA commands
NQA client commands
advantage-factor
Use advantage-factor to set the advantage factor to be used for calculating Mean Opinion Scores
(MOS) and Calculated Planning Impairment Factor (ICPIF) values.
Use undo advantage-factor to restore the default.
Syntax
advantage-factor factor
undo advantage-factor
Default
The advantage factor is 0.
Views
Voice operation view
Predefined user roles
network-admin
Parameters
factor: Specifies the advantage factor in the range of 0 to 20.
Usage guidelines
The evaluation of voice quality depends on users' tolerance for voice quality. For users with higher
tolerance for voice quality, use the advantage-factor command to set an advantage factor. When
the system calculates the ICPIF value, it subtracts the advantage factor to modify ICPIF and MOS
values for voice quality evaluation.
Examples
# Set the advantage factor to 10 for the voice operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type voice
[Sysname-nqa-admin-test-voice] advantage-factor 10
codec-type
Use codec-type to configure the codec type for the voice operation.
Use undo codec-type to restore the default.
Syntax
codec-type { g711a | g711u | g729a }
undo codec-type
Default
The codec type for the voice operation is G.711 A-law.

HPE FlexNetwork 5130 HI SERIES Specifications

General

Brand	HPE
Model	FlexNetwork 5130 HI SERIES
Category	Switch
Language	English