15
destination host
Use destination host to configure the destination host name for the operation.
Use undo destination host to restore the default.
Syntax
destination host host-name
undo destination host
Default
No destination host name is configured for the operation.
Views
UDP tracert operation view
Predefined user roles
network-admin
Parameters
host-name: Specifies the destination host name, a case-sensitive string of 1 to 254 characters. The
host name can contain letters, digits, hyphens (-), underscores (_), and dots (.), but consecutive dots
(.) are not allowed. If the host name is a series of dot-separated labels, each label can contain a
maximum of 63 characters.
Examples
# Specify www.test.com as the destination host name for the UDP tracert operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-tracert
[Sysname-nqa-admin-test-udp-tracert] destination host www.test.com
destination ip
Use destination ip to configure the destination IPv4 address for the operation.
Use undo destination ip to restore the default.
Syntax
destination ip ip-address
undo destination ip
Default
No destination IPv4 address is configured for an operation.
Views
ICMP echo/TCP/UDP echo operation view
DHCP/DLSw/DNS/FTP/HTTP/SNMP operation view
UDP tracert operation view
ICMP jitter/path jitter/UDP jitter/voice operation view
DNS/ICMP/SSL/TCP/TCP half open/UDP template view
To Next Page
Loading...
Need help?
General