HPE FlexNetwork 5130 HI SERIES

336
[Sysname] info-center logbuffer size 50
# Restore the default maximum log buffer size.
<Sysname> system-view
[Sysname] undo info-center logbuffer size
Related commands
display logbuffer
info-center enable
info-center logfile directory
Use info-center logfile directory to specify the directory to save the log file.
Syntax
info-center logfile directory dir-name
Default
The log file directory is flash:/logfile.
Views
System view
Predefined user roles
network-admin
Parameters
dir-name: Specifies a directory by its name, a string of 1 to 64 characters.
Usage guidelines
The specified log file directory must have been created.
The log file uses the .log extension.
This command cannot survive an IRF reboot or a master/subordinate switchover.
Examples
# Set the log file directory to flash:/test.
<Sysname> mkdir test
Creating directory flash:/test... Done.
<Sysname> system-view
[Sysname] info-center logfile directory flash:/test
Related commands
info-center logfile enable
info-center logfile enable
Use info-center logfile enable to enable the log file feature.
Use undo info-center logfile enable to disable the log file feature.
Syntax
info-center logfile enable
undo info-center logfile enable