106
Examples
# Configure the device to operate in broadcast client mode and receive NTP broadcast messages on
VLAN-interface 1.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] ntp-service broadcast-client
Related commands
ntp-service broadcast-server
ntp-service broadcast-server
Use ntp-service broadcast-server to configure the device to operate in NTP broadcast server
mode and use the current interface to send NTP broadcast packets.
Use undo ntp-service broadcast-server to remove the configuration.
Syntax
ntp-service broadcast-server [ authentication-keyid keyid | version number ] *
undo ntp-service broadcast-server
Default
The device does not operate in any NTP association mode.
Views
Interface view
Predefined user roles
network-admin
Parameters
authentication-keyid keyid: Specifies the key ID to be used for sending broadcast messages to
broadcast clients. The value range for the keyid argument is 1 to 4294967295. If you do not specify
this option, the local device cannot synchronize broadcast clients enabled with NTP authentication.
version number: Specifies the NTP version. The value range for the number argument is 1 to 4, and
the default is 4.
Usage guidelines
After you configure the command, the device periodically sends NTP messages to the broadcast
address 255.255.255.255.
If you have configured the device to operate in broadcast server mode on an interface with the
command, do not add the interface to any aggregate group. To add the interface to an aggregate
group, remove the configuration of the command.
Examples
# Configure the device to operate in broadcast server mode and send NTP broadcast messages on
VLAN-interface 1, using key 4 for encryption. Set the NTP version to 4.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] ntp-service broadcast-server authentication-keyid 4 version 4
Related commands
ntp-service broadcast-client
To Next Page
Loading...
Need help?
General